Carlton 1712 Návod k obsluze stáhnout pdf (Strana 105)

12” CHIPPER SERVICE

CUTTER SYSTEM

79

• Use the handle and put the anvil back

through the slot. Rotate the anvil back

90

° to insert the anvil bolts.

• Make sure the hardware is replaced in

the correct order. The square washer has

to be next to the machine. For both

anvil bolts, the adjuster eyebolt would

go on next. The lock washer will go

closest to the head of the bolt on all

bolts.

• The adjuster bolts must be inserted

through the slot provided to make

clearance adjustments. A flat washer

goes between the nut on the adjuster bolt

and the plate.

• Tighten the anvil bolts loosely. Put a

flat washer and a nut back on the outside

of each adjuster bolt. Do not tighten the

nut until clearance has been set.

• ALWAYS CHECK & SET KNIFE TO

ANVIL CLEARANCE AFTER

REMOVING AND REPLACING

KNIVES OR ANVIL.

• Go back to the Check/Adjust Clearance

earlier in this section.

• After clearance has been set be sure to

tighten the anvil bolts and torque to

75 ft. lbs.

• Tighten the nuts on the adjuster bolts.

• ALWAYS REMEMBER TO CLOSE

THE CUTTER DISK HOOD AFTER

SERVICING CUTTER DISK.

• INSTALL THE HOOD LOCK PIN

AND PADLOCK.

•

Check condition of cutter disk hood.

Make sure the hinges are not damaged

and that the hood closes completely with

no gaps or openings; check both sides.

If there are any problems go to Servicing

Cutter Disk Hood later in this section.

REPLACE ANVIL –

PUT THROUGH

OPENING &

ROTATE BACK 90°

HARDWARE ORDER

ANVIL BOLTS:

LOCK WASHER NEXT

TO BOLT HEAD

ADJUSTER BOLT IN

BETWEEN WASHERS

SQUARE WASHER ON

LAST (NEXT TO

MACHINE)

1 2 ... 100 101 102 103 104 105 106 107 108 109 110 ... 164 165

Komentáře k této Příručce

Žádné komentáře