Carlton 2518 Návod k obsluze stáhnout pdf (Strana 105)

18” DRUM SERVICE

CUTTER SYSTEM

78

DANGER:

• TURN ENGINE OFF

• REMOVE IGNITION KEY

• DISENGAGE CLUTCH

• PUT FEED CONTROL BAR IN

NEUTRAL

• ALLOW CUTTER DRUM TO

COME TO A COMPLETE STOP

• ALLOW ALL PARTS TO COOL

COMPLETELY

• INSTALL CUTTER DRUM

LOCK PIN

ANVIL REPLACEMENT

• Check the anvil for wear when knives

have been changed and clearance is

being set. The anvil has two working

edges that can be used. Rotate the anvil

to a new working edge unless both edges

are worn and the anvil needs to be

ground or replaced.

• The edge of the anvil can be ground to

get more use. The angle on the end of

the anvil is 59° maintain this angle when

grinding. DO NOT grind the anvil to the

point that all the adjustment capability is

gone, replace with a new anvil. DO

NOT grind more than 1/8” per side.

• The anvil is hardened steel made to

Carton’s specifications. Use only

Carlton anvils as replacements or

damage may occur. Purchase the new

anvil from Carlton or an authorized

dealer.

• To rotate or replace the anvil, remove

the anvil bolts and washers. There are

six anvil bolts, each with a flat washer

and a lock washer.

• There are two adjuster eyebolts that two

of the anvil bolts go through.

• Loosen the nuts on the inside of the

bracket on each adjuster bolt.

• Remove the nut on the outside of the

bracket on each adjuster bolt.

DANGER: MAKE SURE THE IGNITION KEY HAS

BEEN REMOVED AND MACHINE CAN’T BE STARTED

BEFORE SERVICING ANY PART OF THE CHIPPER.

1 2 ... 100 101 102 103 104 105 106 107 108 109 110 ... 198 199

Komentáře k této Příručce

Žádné komentáře