Carlton 2518 Návod k obsluze Strana 51

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 199
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 50
18” DRUM MACHINE CONTROLS
24
FEED WHEEL CLEAN OUT DOOR
There is a drop-down door to clean
excess debris out from under the bottom
feed wheel. This will help to keep the
chipper from getting clogged or stopped
up. Use the handles, located on both
sides behind the infeed chute, and drop
the door down to remove debris, then
close and secure the door. Should be
cleaned frequently to prevent damage to
clean out door and to prevent clogging
the chipper. DO NOT open the clean
out door until the chipper has been shut
down and all parts have come to a
complete stop, danger of flying debris
could cause injury.
BRAKES & REAR LIGHTS
The chipper’s brakes and lights are
connected to the tow vehicle actuator to
be activated by the tow vehicle
operation.
See the Machine Wiring section of
this manual for wiring diagram.
BREAKAWAY SWITCH
The breakaway switch is a safety device
designed to activate the chipper brakes if
it ever becomes uncoupled from the tow
vehicle. A cable attached to the
breakaway switch is attached to the tow
vehicle so that the breakaway switch will
separate and cause the brakes to be
applied to slow the chipper.
CLEAN-OUT DOOR
HANDLES
Zobrazit stránku 50
1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 198 199

Komentáře k této Příručce

Žádné komentáře